安全滑觸廠家對產品的常見問題解析：

很多時候，客戶不了解滑觸線，因而會問一些安全滑觸線常見問題，本文就此對客戶對滑線的疑問做簡要解答。

Many times, customers do not know the sliding contact line, so they will ask some common questions about safety sliding contact line. This article will give a brief answer to customers'questions about sliding line.

1、我的車間是5T的行車，就一臺，需要用什么樣的滑觸線？

1, my workshop is 5T's driving. Just one. What kind of sliding line should I use?

5T的行車功率比較小，可以采用單極安全滑觸線200A，或者是4極10平50A的多極安全滑觸線，如果是室內用滑觸線，作者建議用單極安全滑觸線；

The power of 5T is relatively small. It can use unipolar safe sliding contact wire 200A or multipolar safe sliding contact wire of 4 poles 10 flat 50A. If indoor sliding contact wire is used, the author suggests unipolar safe sliding contact wire.

2、我的起重機是室外用的，功率在97kw左右，用什么滑觸線較好？

2, my crane is for outdoor use, and the power is about 97kw. What kind of slide line is better?

室外用滑觸線一般采用金屬外殼多極安全滑觸線，或者是采用單極安全滑觸線，外加防雨罩。97KW的起重機可以用320A的單極安全滑觸線；

Outdoor sliding contact wire usually adopts metal shell multi-pole safe sliding contact wire, or single pole safe sliding contact wire, plus rain shield. 97KW's crane can use 320A's unipolar safety slide line.

3、請問滑觸線是定尺的嗎？我的車間導軌有拐彎的地方，滑觸線可以應用嗎？

3. Is the slide line fixed? There is a turning point in the guide of my workshop. Can the sliding contact line be applied?

滑觸線是定尺的，以濟南德瑪?shù)幕|線為例，DMHX單極安全滑觸線，500A以下的滑觸線，包括500A，長度都是4.5米一根；500A以上的都是6米一根；DMHP多極管式安全滑觸線是4米一根；DMGH剛體滑觸線為6米一根；滑觸線可以做成弧形的，但有要求，一般要求弧形半徑要大于等于1.5米，滑觸線方可以做成弧形的。

Take Jinan Dema's sliding contact line for example, DMHX unipolar safe sliding contact line, the sliding contact line below 500A, including 500A, is 4.5 meters in length; all over 500A are 6 meters in length; DMHP multipolar tube safe sliding contact line is 4 meters in length; DMGH rigid body sliding contact line is 6 meters in length; sliding contact line can be made into arc. But there are requirements. Generally, the arc radius should be greater than or equal to 1.5 meters. The sliding contact line can be made into an arc.

4、車間內有兩臺行車，兩臺都是1T的，起升高度有6M，車間長度有45米，起重物最大重量1噸 ，起吊速度8M/MIN，用哪種滑觸線較好，需要多少米？

4. There are two traveling cars in the workshop, both of which are 1T. The lifting height is 6M, the length of the workshop is 45m, the maximum weight of the lifting object is 1 ton, and the lifting speed is 8M/MIN. Which kind of sliding contact line is better and how many meters is needed?

兩臺1T的行車，推薦用200A單極安全滑觸線，如果按照三相四線制來安裝，需要45*4米的滑線，也就是180米的滑線。

Two 1T vehicles are recommended to use 200A single-pole safe sliding contact line. If they are installed according to three-phase four-wire system, 45*4 m sliding line, or 180 m sliding line, is required.

5、比較老的一個廠房擴建，既有的是HFP4U50這個滑觸線型號，不清楚是哪個廠家的，你們的同型號產品能否跟這個接續的？

5. An older factory building expansion, both HFP4U50 sliding contact model, is not clear which manufacturer, your same model products can follow this?

各個廠家生產的滑觸線型號不同，采用的生產模具不同，做出的產品截面積也就不同，建議購買原廠家的滑觸線產品。

Each manufacturer produces different types of slippery contact wires and adopts different production moulds. The cross-sectional area of the products is also different. It is suggested to buy the original manufacturer's slippery contact wires.

6、單極安全滑觸線哪些是免費的？這個集電器一般可以使用多長時間？集電器行駛速度有沒有要求？

6, which are free of unidirectional safety slide lines? How long can this collector run? Is there any requirement for collector speed?

答：和單極安全滑觸線配套的免費附件有：角鋼支架、鋁接頭、接頭護套、提掛架、固定架、端冒、動力輸入、集電器支架等附件；集電器的使用壽命和行車的工作時間成正比例，以濟南德瑪電氣的集電器來說，如果行車全天24小時運轉，集電器可以使用在1年以上，超過1年要檢查磨損情況，根據情況更換碳刷；集電器的行駛速度和行車有關系，只要行駛速度不超過200/分鐘，集電器就可以正

Answer: Free accessories for unipolar safety sliding contact wire include: angle steel bracket, aluminium joint, joint sheath, lifting hanger, fixing frame, end riser, power input, collector bracket, etc. The service life of collector is proportional to the working time of the vehicle. For the collector of Jinan Dema Electric, if driving 24 hours a day, the collector of Jinan Dema Electric Co. Hour running, collector can be used for more than one year, more than one year to check wear and tear, according to the situation to replace carbon brushes; collector speed and driving is related, as long as the speed does not exceed 200/min, collector can be positive.

更多滑觸線資料 盡在濟南德瑪電氣有限公司